If your splash around ceiling fan's lights no longer work, the culprit is usually the pull-chain light electrical switch mounted on the bottom of the fan.
Hither's how to examine and supplant the switch.
To determine if the pull mountain chain switch is abnormal:
-
- Turn off the office to the fan at the circuit breaker.
-
- Remove the cover plate happening the bottom of the lover.
-
- Disconnect the wires coming from the switch to the lights.
-
- Make sure the wires are not touching anything, then turn the power back on at the surf.
-
- Check the switch wires with a electric potential tester to get wind if power is sexual climax from the switch to the lights.
-
- If electricity is present below the switch, the problem is either in the wires going to the dismount, the lightbulb sockets, or the light-footed bulbs.
-
- If electrical energy is not present on a lower floor the switch, change by reversal the exponent to the fan back off.
-
- Disconnect the wires coming into the switch from the fan.
-
- Make a point the wires are not touching anything, then turn the power indorse on at the circuit breaker.
-
- Check the wires coming into the switch from the fan with a voltage tester to see if power is coming from the fan to the switch.
-
- If electricity is non coming from the buff to the switch, the trouble is with the rooter wiring rather than the switch.
-
- If electricity is coming from the fan to the switch, the problem is with the pull chain switch.
- If the throw is the problem, dispatch the switch, replace it with a new switch, reattach the wires, crook the power back happening, and pull the chain along the switch to see if the lights make.
Scout this video to find unconscious much.
Promote Info
- How to Replace a Paddle Ceiling Fan Pull Chain Switch (article)
- How to Stop Wobble and Vibration in a Paddle Ceiling Fan (article)
- How to Deposit an Exterior of Balance Ceiling Rooter (TV)
- How to Control a Ceiling Fan Without a Wall Switch (article)
- How to Instal a Boat paddle Ceiling Fan (video)
VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their cap fan light kit could be repaired without replacing the uninjured thing. If the fan placid works well, it's worth looking into the light kit.
If there are no lax wires visible, the culprit is in all likelihood a faulty pull chain exchange. To check, turn remove the power at the breaker box, and disconnect the wires coming from the change to the lights. Make up sure that the wires are non touching anything before you turn the power rachis along, and mental test the wires with a voltmeter.
If No voltage is present, turn the mightiness back up, and gulf the wires coming into the switch from the fan. Once again, be sure no wires are touching anything before turning on the power to screen them with the meter.
If voltage is present above the flip, merely not below IT, then the switch is bad. A replacement pull chain of mountains switch is exclusive a few dollars and should make love into exactly the same location equally the old one.
With the power off, connect cardinal side of the switch to the wires coming in from the fan, and the opposite side to the wires feeding the lights.
Lowes White Ceiling Fan With Lots of Light
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Komentar
Post a Comment